Flowserve ISC1BX Manual de usuario descargar pdf (Pagina 2)

2 Disassembly

When disassembling seal, inspect for conditions which may have caused the

need for the seal to be removed from service. If seal was removed due to

premature failure, determine what conditions caused that failure and correct any

problems prior to returning the repaired seal to service. For assistance with seal

failure analysis, please contact your Flowserve representative.

These instructions are written for trained, experienced technicians familiar with the basic

principles and tools involved in the installation, care and service of mechanical seals and seal

support systems. A complete reading of these instructions by personnel in contact with the

equipment is essential to safety. Incorrect installation, operation or maintenance can result in

personal injury or death to personnel and damage to the equipment.

1 Nomenclature

Note: Primary seal O-rings (P and 6) are

the same size and cross section.

34 Bellows Assembly

3A Mating Ring

P Mating Ring O-Ring

6 Bellows O-Ring

11 Sleeve O-Ring

G Gasket

1 Gland Assembly

1B Gland Drive Ring

CT Centering Tab

K Centering Tab Cap Screw

SL Sleeve Assembly

M Vibration Dampener

M1 Bellows Vibration Dampener

10A Driver Ring

9 Sleeve Collar

13 Cup Point Set Screw

13A Quarter Dog Set Screw

Table 1

Figure 1

Seal Parts that are always replaced

• Bellows Assembly 34

• Mating ring 3A

• All O-rings P , 6 , 11

• Gland gasket G

• Vibration dampener M

• Bellows Vibration dampener M1

• Centering tabs CT and cap screws K

• Cup point and quarter dog set screws 13 and 13A

Reconditionable Seal Parts

• Gland assembly 1

• Sleeve assembly SL

• Sleeve collar 9

1 13910A

34 P

K 13A

CT1B

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Flowserve ISC1BX Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Flowserve ISC1BX