Flowserve CPM Series Manual de usuario descargar pdf

Installation

Instructions

Experience In Motion

CPM Series

Single, cartridge mounted, ﬂexible stator pusher

seal designed for general service applications

CPM PX

1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Instructions

Installation InstructionsExperience In MotionCPM SeriesSingle, cartridge mounted, ﬂexible stator pusher seal designed for general service applications

Pagina 2 - 1 Equipment Check

2DescriptionThe CPM PX seal is a cartridge mounted mechanical seal, designed for ease of installation and reliable operation. No seal setting dimensio

Pagina 3

3Seal Chamber Requirements Figure 11.6 Check gland bolting to ensure that bolt diameter (M) and bolt

Pagina 4 - 2 CPM PX Installation

42 CPM PX InstallationNote: No seal setting measurements are needed to install the CPM PX seal. Instructions are for vertically split case end-s

Pagina 5 - Figure 5

52.4 Install the pump back plate (seal chamber) and bolt it in place on the bearing frame. See Figure 4.Figure 4Figure 5PumpBack PlateBearing Frame

Pagina 6 - Figure 6

62.8 Rotate the setting devices 180° from the sleeve drive collar and retighten. See Figure 6. Loosen the hex head bolts attaching the bronze

Pagina 7 - 5 Repair

7 4 Operational Recommendations 4.1 Do not exceed corrosion limits. The CPM PX seal is designed to resist corrosion by most chemicals. However, do n

Pagina 8 - TO REORDER REFER TO

TO REORDER REFER TOB/M #F.O.FIS164eng REV 03-14 Printed in USAﬂowserve.comTo ﬁnd your local Flowserve representativeand ﬁnd out more about Flowserve C