Flowserve Logix 3200IQ Digital Positioner Manual de usuario descargar pdf (Pagina 2)

Flowserve Corporation 1350 N. Mountain Springs Parkway 1978 Foreman Dr.

Flow Control Division Springville, Utah 84663-3004 Cookville, TN 38501

www.flowserve.com Phone: 801 489 2233 Phone: 931 432 4021

FCD AXAIM3200-00 9/04 Page: 2 of 32

Automax Logix 3200IQ Digital Positioner

Installation, Operation and Maintenance Instructions

Figure 1: Logix 3200IQ Digital Positioner

Positioner Overview

The Logix 3200IQ digital positioner is a two-wire

4-20 mA input digital valve positioner. The positioner is

configurable through the local user interface. The Logix

3200IQ utilizes the HART protocol to allow two-way

remote communications with the positioner. The Logix

3200IQ positioner can control both double- and single-

acting actuators with linear or rotary mountings. The

positioner is completely powered by the 4-20 mA input

signal. Start up current must be at least 3.6 mA without

AO card or 3.85 mA with AO card.

Specifications

Table I: Electrical Specifications

Power Supply Two-wire, 4-20 mA

10.0 to 30.0 VDC

Compliance Voltage 10.0 VDC @ 20 mA

495 Ω @ 20 mA Typical

Effective Resistance Add 20 Ω when HART

communication active

Communications HART Protocol

Minimum Operating 3.6 mA without AO board

Current 3.85 mA with AO board

Maximum Voltage 30.0 VDC

Table II: SoftTools Suite Software Specifications

Computer Minimum Pentium processor running

Windows 95, 98, NT, 2000, XP, 32 MB

total memory (64 MB recommended),

30 MB available hard disk space,

CD-ROM drive

Ports 1 minimum available with 8 maximum

possible. (Can also communicate via

PCMCIA and USB connections)

HART Modem RS-232/PCMCIA card/USB

HART Filter May be required in conjunction with

some DCS hardware

HART MUX MTL 4840/ELCON 2700

Table III: Environmental Conditions

Standard

-4° to 176°F

Operating Temperature (-20° to 80°C)

Range

Low

-40° to 176°F

(-40° to 80°C)

Transport and Storage

Temperature Range

-40° to 176°F (-40° to 80°C)

Operating Humidity 0 to 100% non-condensing

Note: The air supply must conform to ISA Standard

ISA 7.0.01 (a dew point at least 18 degrees Fahrenheit

below ambient temperature, particle size below five

microns – one micron recommended – and oil content

not to exceed one part per million).

Table IV: Physical Specifications

Housing Material Cast, powder-painted aluminum,

stainless steel

Soft Goods Buna-N / Fluorosilicone

Weight

8.3 pounds (3.9 kg) aluminum

20.5 pounds (9.3 kg) stainless steel

Table V: Positioner Specifications

Deadband <0.1% full scale

Repeatability <0.05% full scale

Linearity

<0.5% (rotary), <0.8%,

(sliding stem) full scale

Air Consumption

<0.3 SCFM (0.5 Nm

/hr)

@ 60 psi (4 barg)

1 2 3 4 5 6 7 ... 31 32

Comentarios a estos manuales

Sin comentarios

Flowserve Logix 3200IQ Digital Positioner Manual de usuario Pagina 2

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Flowserve Logix 3200IQ Digital Positioner