Flowserve MX Dashboard Limitorque Manual de usuario descargar pdf (Pagina 6)

FCD LMENIM2338-01

To configure the MX/QX “port” setting, refer to the

LMEIM2306/3306 for detailed instructions.

To use the MX/QX Downloader option on the dashboard, the

MX/QX must be configured for IRDA in the “port” setup.

The ModSim option on the Dashboard is supported either

via IR or BT.

Setup example for the IR setting in the “port” menu:

Once the port is configured, Dashboard may be used to

communicate with the MX/QX via the user selected Local port.

Note: When using the IR option, line of sight is required with

the device. For best results hold the IR device approximately

12 cm or less, from the actuator. BT option supports a

maximum distance of 10 meters from the device.

Configuring the MX/QX BT option:

•Inthe‘ports’menu,selecttheBTport.

•EachBT-equippedMX/QXhasauniqueidentifier.Notefor

future reference.

•ConfiguretheBTpassword.Defaultis“default123456789,”a

maximum of 16 alphanumeric characters.

•Theuserhastheoptiontodisablethepassword.

NOTE: Limitorque strongly recommends the use of a

non-default password on the MX/QX for security reasons.

•TheMX/QXisnowreadyforusewiththeLimitorque

Dashboard application.

MX/QX Configuration

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Sin comentarios

Flowserve MX Dashboard Limitorque Manual de usuario Pagina 6