Flowserve QX Limitorque Manual de usuario Pagina 53

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 82
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 52
53
Limitorque QX Electronic Actuator FCD LMENIM3314-00 – 5/11
flowserve.com
Note: The encoder rotor can only be mated to the encoder shaft in one position. The encoder shaft has 3 flats that
must align correctly to the encoder rotor ID and ribs. See Figure 5.3 for reference.
Step 4
Install the three M4 screws thru encoder and standoff assembly (#17-6) and tighten. Take note not to over tighten.
Step 5
Reconnect encoder ribbon cable to motor controller board. (See section 6 for connector position on motor control
board).
Vista de pagina 52
1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Comentarios a estos manuales

Sin comentarios