Flowserve Circulator Manual de usuario descargar pdf (Pagina 10)

12. Slide tting nuts into place and nger tighten.

13. Remove the tting nuts and ferrules from the ttings

on the right side of the heat exchanger and the lter.

Slide them onto the “L” shaped tubing.

14. Insert the “L” shaped tube into the right side of the heat

exchanger and the lter. Verify tubing ends are the

correct length. Cut to t if required. Proceed to the next

step once the tubing is the correct length.

15. Slide tube tting nut and ferrule onto each end of the

tubing.

16. Insert tubing into the ttings on the heat exchanger

and lter.

17. Slide tting nuts into place and nger tighten.

18. Square the mounting brackets with the manifold block.

See Figure 4. Tighten the mounting bolts and the U-

bolt nuts. Do not over tighten.

19. Hold tubing into position and tighten each nut with a

wrench until tight. Do not over tighten.

20. Disconnect the existing cooling media lines from the

reservoir’s internal heat exchanger.

21. Apply Teon tape and/or Jomar pipe dope or equal to

the 1/2” NPT plug threads. Start no closer to the end

of the threads than the 2nd thread.

22. Thread the plugs into the reservoir’s internal heat

exchanger and tighten. Do not over tighten.

23. Installation is complete.

24. It is the responsibility of the customer to connect to the

heat exchanger cooling media ports.

Note: For additional cooling capacity run cooling media

through both the internal and external cooling coils

in series.

mounting

bracket

4.50"

tubing and

ttings

heat

exchanger

cooling port

orientation

mounting

bracket

Figure 4

Figure 5

1 2 ... 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Flowserve Circulator Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Flowserve Circulator