Flowserve Circulator Manual de usuario

Instruction,Operation and Maintenance ManualExperience In MotionFlowserve CirculatorTable of ContentsSection A Installation, Start-up and Maintenanc

12. Slide tting nuts into place and nger tighten.13. Remove the tting nuts and ferrules from the ttings on the right side of the heat exchan

11Section D: Customer DrawingsNote: The following documents are typically provided as part of the order documentation package along with this IOM. Ap

TO REORDER REFER TOB/M #F.O.FIS187eng ORG 4/10 Printed in USAflows er ve .c omTo find your local Flowserve representativeand find out more about Flowserv

2Section A: Installation, Start-up and Maintenance1 Introduction1.1 This manual is a valuable tool covering the circulator you have purchased.1.2 D

3Do not, under any circumstances, use the circulator to flush the interconnecting piping/tubing. Using the cir-culator to flush the interconnecting pipi

43.5 Pressure relief valve reset procedureThe pressure relief valve on the right end of the mani-fold is factory set at 450 psig (3103 kPa) and shoul

55 TroubleshootingProblem Probable CauseUnable to maintain Pressure Low pressure control valve setting: Follow the procedure in this document to

6Section B: Piping and Instrumentation Diagram Customer specific drawings can be found in Appendix 1.Key contained in manifold block contained in

7Section C: Kit Installation Instructions Available kit optionsOption 1: Pressure switch Part code UKDPU9802Option 2: Safety feature (accumulator)

8Option 2 The safety feature kit includes: • Accumulator, 1-1/4” NPT • 1-1/4” NPT pipe nipple • 1/4” tubing and tube ttingsKit Installation

9 Option 3 The level switch kit includes: • Level switch, 3/4” NPTKit Installation Instructions1. Apply Teon tape and/or Jomar pipe dope or equa