
The Man/Auto menu is used to change between manual and
automatic modes.
The menu contents are shown in the figures on the right
and the various texts are described below:
AUT, OK = MAN
Positioner in automatic mode
MAN, OK = AUT
Positioner in manual mode
In the MAN mode, the value of POS can be changed using The push- buttons increase/decrease the value
in steps. The value can also be changed in the same way as for the other parameter values, as described on page 20.
Other functions
C+ can be fully opened by pressing and then immediately OK simultaneously.
C+ can be fully opened for blowing clean by pressing and OK simultaneously.
The Shift Menu is used to choose between the basic menu and the full menu.
The menu contents are shown in the figures on the right and the various
texts are described below:
No Full menu selected.
Yes Basic menu selected.
When changing between MAN
and AUT mode, the OK button
must be pressed for 3 seconds.
Full Menu can be locked with
a passcode, see Setup menu.
Comentarios a estos manuales