Installation InstructionsExperience In MotionDurametallic® Double CRODual single coil spring friction drive for applications with water lubrication pr
1 Equipment Check2Seal Chamber Requirements Figure 11.5 Check assembly drawing included with the Double CRO seal for specic seal desig
31.7 Check gland pilot and bolt holes to ensure they are adaptable to the equipment and are the same as shown on the assembly drawing.1.8 Handle
2.5 Lubricate the other stationary face seat gasket O-ring with water or soap solution and place this O-ring on the back shoulder of the remaining
3.3 Install the rotating seal parts on the shaft or sleeve one piece at a time: • Inner rotating face with rotating face gasket O-ring. •
64 Operational Recommendations4.1 Do not start up the equipment dry. Vent air from the casing of the pump and the seal chamber before startup.
75 RepairsThis product is a precision sealing device. The design and dimension tolerances are critical to seal performance. Only parts supplied by Flo
TO REORDER REFER TOB/M #F.O.FIS133eng 10/13 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve Corpo
Comentarios a estos manuales