Installation InstructionsBW Seals® Q, QB SeriesGeneral ServiceBalanced Pusher SealQ, QB, QBQ, QBS, QBU, QBQ LZExperience In Motion
21 Equipment Check1.1 Follow plant safety regulations: • lock out motor and valves. • wear designated personal safety equipment. • relieve any
32 Assembly of Seal Components2.1 Prepare rotating assembly for installation. The rotating assembly is comprised of the spring holder, springs, reta
43.3 O-ring Mounted Stationary Face 3.3.1 Assemble seat gasket to stationary face (lubricate gasket with silicone base grease only, unless other
54.3 Verify seal setting (SS) reference dimension on the seal drawing. This is the dimension from the seal chamber face to a machined step or locator
65 Cartridge Mount5.1 For proper seal installation you must have current seal assembly drawing for your application.5.2 Inspect pump shaft. Clean
7Type 3 (setting blocks) Figure 7Setting Block • Tighten drive collar set screws to shaft. • Loosen and remo
TO REORDER REFER TOB/M #F. O .FIS135eng REV 07/13 Printed in USAFlowserve Corporation has established industry leadership in the design and manufactur
Comentarios a estos manuales