Flowserve RIS Seal Manual de usuario descargar pdf (Pagina 7)

4.4 Position9and 9-1jamnutsasfaraspossibletoeachendof10

studsotheywillnotrestrictaxialmovementof101clampring.

4.5 Installrotatingfaceassembly.SeeFigure7.

 4.5.1 Cleantheendoftheshaftsleeveofanydirt(orshaft

   shoulderifasleeveisnotused)andremoveanynicks

or burrs.

4.5.2 Clean both rotating and stationary seal faces with

alcohol by applying it to a lint free tissue and wiping the

   sealface.Makesurealldirtandgreaseareremoved.

4.5.3 Install the gasket(s) as shown on the seal assembly

drawing.

4.5.4 Install the assembly onto the shaft.

4.6 Install the pump impeller.

4.6.1 Apply grease to the impeller threads only.

4.6.2 Install the appropriate gasket or O-ring as described on

the form drawing.

4.6.3 Be sure the impeller is tight after assembly.

Assemble the Rotating Face Assembly Figure7

Impeller

SealCarrier

240

Bolt

Clamp Ring

101

Stud10

Bolt

40-1

Jam Nut

EndPlate139

O-ring

Cover

Jam Nut

9-1

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Flowserve RIS Seal Manual de usuario Pagina 7