Flowserve Circpac MD Manual de usuario

Busca en linea o descarga Manual de usuario para Hardware Flowserve Circpac MD. Flowserve Circpac MD User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 8
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Installation
Instructions
Experience In Motion
Circpac MD
Split Segmented
Circumferential Gas Seal
Vista de pagina 0
1 2 3 4 5 6 7 8

Indice de contenidos

Pagina 1 - Instructions

Installation InstructionsExperience In MotionCircpac MDSplit Segmented Circumferential Gas Seal

Pagina 2

1 Equipment Check and Seal Preparation1.1 Refer to Figure 1 for sleeve/shaft and equipment requirements.1.2 The equipment sleeve/shaft must be clea

Pagina 3 - Figure 5

32 Seal Installation (Split Housing Designs)Seal components are assembled in the following order: housing gasket (if separate), bottom housing half,

Pagina 4 - Figure 8

4Figure 62.5 Select a ring segment that does not havethedrivepin.Positionitoverthegroove in the lower housing half. Make sure the numbered si

Pagina 5 - Figure 9

52.9 Rotate the ring assembly until the drive pin engages the pin slot at the housing joint. 2.10 Repeat steps 2.3-2.9 with all segmented rings. Fi

Pagina 6 - Figure 13

62.13 Center the housing assembly on the shaft as required. If centering devices are used, release any housing supports so that the centering devices

Pagina 7 - 5 Repairs

7 3 Seal Installation (Non-split Housing Designs) 3.1 Circpac MD seals with non-split housings are pre-assembled at the factory for cartridge inst

Pagina 8 - TO REORDER REFER TO

TO REORDER REFER TOB/M #F.O.FIS153eng REV 01/03 Printed in USAflowserve.comTo find your local Flowserve representativeand find out more about Flowserve C

Comentarios a estos manuales

Sin comentarios