Flowserve SLC Series Interseal Manual de usuario descargar pdf (Pagina 6)

4.7 Slide retaining bolts through the rear face of the adapter plate and screw into

seal ange/gland. Evenly tighten retaining bolts to pull the seal into the adapter

t. See Figure 7.

Draw Cartridge into Adapter Using Attachment Bolts Figure 7

With the Spacer Ring Removed

Evenly Tighten Flange/Gland Bolts

to Start the Seal into the Adapter

Insert the Spacer Ring and

Continue Even Tightening

of the Bolts until the

Flange/Gland is Properly Seated

4.8 Once the seal ange/gland has started into the adapter t, remove the retaining

bolts and insert the spacer ring. Continue even tightening of the bolts until the

seal ange/gland is properly seated. See Figure 7. Some seals do not require

the use of the spacer rings; consult job drawing.

4.9 If seal is directly mounted on shaft and not on the pump sleeve install impeller

spacer hook sleeve (possibly modied), impeller, and suction cover.

4.10 Make any necessary impeller adjustments.

Important: Loosen bearing assembly and drive belts only enough to make

adjustment. Fully tighten bearing assembly bolts after adjustment.

Torque Value Chart N-m (ft-lb) Figure 8

Split Clamp/ Group 4-5 Taper

Drive Cap Ring Clamp/ Drive Collar

Screws Drive Cap Screws Set Screws

Fastener Alloy Alloy Stainless Alloy

Size Steel Steel Steel Steel

5/16” 33 - 35 27 - 30 14 - 16 18 - 20

(24 - 26) (20 - 22) (10 - 12) (13 - 15 )

3/8” 54 - 61 33 - 37 20 - 23 30 - 34

(40 - 45) (24 - 27) (15 - 17) (22 - 25)

1/2” 122 - 136 - 43 - 49 68 - 75

(90 - 100) (32 - 36) (50 - 55)

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Flowserve SLC Series Interseal Manual de usuario Pagina 6