Flowserve VKP 40Ex Manual de usuario descargar pdf (Pagina 10)

Connecting and Commissioning Data Collector VKPN 40Ex, VKPN 40

Connecting data collector VKPN 40Ex or VKPN 40 to a PC

Connect the power supply unit of the connecting cable VKPA 40 with an earthed socket and insert the circular plug of the connecting

cable into the left-hand jack of the data collector VKPN 40Ex / VKPN 40.

■ If the power supply unit is not connected the data collector cannot communicate with the PC.

Connect the serial plug of the connecting cable with the PC. Use a commercially available interface connection USB-RS 232 to connect

the data collector via a USB interface to PC. Then conﬁrm the selected interface (Com 1, Com 2, Com 3, Com 4 or Com 5) in the

TRAPtest menu EXTRAS/Interface on the PC.

■ Attention: Do not use the connecting cable VKPA 40 in explosionrisk areas!

Connecting measuring transducer VKPS 40Ex to data collector VKPN 40Ex or VPKN 40

■ Note when using the VKPN 40Ex in explosionrisk areas:

Make sure that the measuring transducer VKPS 40Ex is connected to the data collector VKPN 40Ex before you

enter an explosionrisk area. Do not open this connection in explosionrisk areas. The two connected devices

(VKPN 40Ex with VKPS 40Ex) can be in switched-on or switched-off mode when they are carried into an explosion-risk

area.

■ Do not use the data collector VKPN 40 in explosionrisk areas.

Insert the circular plug of the connecting cable VKPS 40Ex into the right-hand jack of the data collector VKPN 40Ex / VKPN 40.

To unplug the cable pull the sleeve of the connector.

Danger

➞

Circular plug

➞

Data collector VKPN 40Ex with connecting cable VKPA 40

Serial plug

➞

Adaptor for

connector

➞

Power supply

unit

➞

Connecting cable

VKPA 40

Data collector VKPN 40Ex,

bzw. VKPN 40 with measuring transducer VKPS 40Ex

Measuring transducer

VKPS 40Ex

➞

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sin comentarios

Flowserve VKP 40Ex Manual de usuario Pagina 10