Flowserve PMV D3 Digital Positioner Manual de usuario descargar pdf (Pagina 18)

The contents of the menu are shown on the next page. The various menu

texts are described below.

Auto-Cal Auto-tuning and calibration of end positions

Start tune Starts the tuning. Questions/commands are displayed during

calibration. Select the type of movement, function, etc. with

and confirm with OK as shown in the chart on the next

page.

Lose prev value? OK? A warning that the value set previously will be lost (not during

the first auto-tuning).

Actuator? rotating Select for rotating actuator.

Actuator? linear Select for linear actuator.

Actuator single act Select for single act.

Actuator double act Select for double act.

Direction? direct Select for direct function.

Direction? reverse Select for reverse function.

In service? Press OK Calibration finished. Press OK to start positioner functioning.

(If ESC is pressed, the positioner assumes the ”Out of service”

position but the calibration is retained).

TravelCal Calibration of end positions

Start cal Start end position calibration.

Lose prev value? OK? A warning that the previously set value will be lost.

Confirm with OK.

The calibration sequence starts.

In service? Press OK Calibration finished. Press OK to start positioner functioning.

(If ESC is pressed, the positioner assumes the ”Out of service”

position but the calibration is retained).

Perform Setting gain

Normal 100% gain

Perform 50%, 25%,

12%, L, M, S Possibility to select a lower gain in steps.

L, M, S Preset values for L, M, S actuators

Factory set Resets all set values and enters Factory Mode. Should only

be used by authorized staff.

Note. Original P. I. D. will always be shown in display

BASIC MENU

CALIBRATE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Sin comentarios

Flowserve PMV D3 Digital Positioner Manual de usuario Pagina 18