Flowserve PSS III Durametallic Manual de usuario descargar pdf (Pagina 10)

10

8 Gland Gasket Installation

8.1 Assembletheglandhalves.

Tighten the cap screws until the

gland joints are metal to metal.

8.2 Wipetheglandgasketgroove

clean with alcohol.

Caution: Consult material safety data

sheets for proper handling of

alcohol.

8.3 Usingapaperclipapplyadot

ofadhesiveintheglandgasket

groove about 6.3mm(.25 inch)

from each side of the split joints,

4 dots total. Then apply dots of

adhesiveintheglandgasket

groove, space about 12.7to

25.4 mm (0.50 to 1 inch)apart.

Do not apply adhesive closer than

6.3mm(0.25 inch)tothesplit

joint.SeeFigure18.

8.4 Centertheglandgasketinthe

gasketgrooveandholditinplace

with hand pressure for 10 seconds

until the adhesive sets. On larger

sizesuseaatplatetoensure

rmequalpressurearoundthe

entire circumference.

SeeFigure19.

8.5 Withthebladeata20°to30°

angle from the vertical cut the

gasket3.0to3.8mm(0.12 to

0.15 inch)fromtheonesplitjoint.

Repeatontheoppositeside,180°

fromtherstcut.  

See Figure 20 and 21.

Figure18

Figure19

Figure 20

3.18 - 3.81 mm

(0.125 - 0.150 inch)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios