Flowserve NRS1-40.1 Manual de usuario descargar pdf (Pagina 31)

Annex

– continued –

Node ID

Should it be necessary to establish other node IDs please take the interdependence of the equipment into

consideration and assign the node IDs for the individual group components according to the following

table:

The node ID

of the second level electrode NRG 1.-40 must be set on site since the equip-

ment features 2 as default factory setting.

Change node ID

With lower terminal strip unplugged:

Set the node ID via code switches Fig.4 (S1 to S7) a specified in the above table "Node ID" by using a

thin blade screwdriver.

Re-insert terminal strip and fasten the fixing screws . Enter the adjusted node ID on the name plate.

The terminal strips of the control unit NRS 1-40.1 are live during operation.

This presents the risk of severe cases of electric shock!

Always

cut off power supply

to the equipment before mounting, removing or connecting

the terminal strips!

A node ID must only be used for one piece of equipment in the CAN bus system.

The node ID 0 is not permissible.

Control unit

NRS 1-40.1

Sensor 1 e. g.

level electrode

NRG 1.-40

as device 1

Sensor 2 e. g.

level electrode

NRG 1.-40

as device 2

Sensor 3 e. g.

level electrode

NRG 1.-41.1

Sensor 4 e. g.

Temperature

transmitter

TRV 5-40

X X+1 X+2 X+3 X+4

1 2 3* 4 5

Factory setting

Reserved area

Note

B C

Danger

Attention

1 2 ... 26 27 28 29 30 31 32 33 34

Comentarios a estos manuales

Sin comentarios

Flowserve NRS1-40.1 Manual de usuario Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware Flowserve NRS1-40.1